1. Skip to Menu
  2. Skip to Content
  3. Skip to Footer>

4. Hardware - how to connect INPUTS?

Thursday, 01 September 2011 22:26

Written by Marcin Kapera

PDF Print E-mail
INPUTS are situated in the middle of pcb and grupped in 8 sections with 16 inputs in each section. Each group has got separate IDC connector as shown on picture. Best for these connections is 16 way flat cable with cable mounted plug.
SKALARKI I/O PEDESTAL (OVERHEAD) : INPUTS section
pedestal_inputs
pedestal_inputs1
1. Connecting momentary, toggle, or rotary switches
All of them can be connected to any available INPUT pin and then configured in Profile Editor.
inputs_momentary
inputs_rotary
inputs_toggle
2. Rotary encoders with 2 bit gray code: - 1 pulse/detent, 2 pulses/detent, 4 pulses/detent
Encoder can be connected to any pair of INPUT pins with only one condition - pins must be in the same group (socket). In Edit Profile window encoder can be configured.
inputs_encoder